Magazine Bowls

METHOD:
1) Rip out magazine sheets that have lotsa colour in them, and colour that goes all the way to the edges cause that is what you will see.
2) Flip over the page you wish to use and start folding corner to corner. Figure out how wide you want your slats to be before beginning and try and make them all the same or else some will stick out.
3) Once you have folded it to the end glue the last flap over.
4) Then run glue along the finished slat and then start to roll, as tightly as you can to create your base. (As you go on DO NOT glue all slats together you want them to be able to move so you can bring the sides up to make the bowl shape.)
5) Now tape the end to keep it nice and tight.

----------------------------------------------------------------------------

ADDING MORE RINGS:
There has been som confusion on this point. The following pics look similar to the ones above but notice I am adding a second ring and you will add every additional ring in this way:The end of this slat is tapped to the base and then tightly wrapped around and then .....:taped again.

6) Continue to make slats and wrap them around the base. Alternate which sides you start to wrap around or else it will start to slant all to one side. After a while you should have a flat disc, once you reach your desired size (its kinda like pottery wheel in this sense!) push your thumbs in the middle and use your fingers to bring up the side of the bowl. When you have it looking the way you want cover the bowl inside and out with two layers of white school glue. As you know it dries clear and keeps your bowl hard and in its shape.

-------------------------------------------------------------------------------

Check for more Details from the original site